LogoLogo
Gen 2.1
Gen 2.1
  • Introduction
  • Kayak
    • Getting Started
      • Assemble your kayak power meter
      • Charge your kayak power meter
      • Configure your kayak power meter settings
        • Blade tip to hand distances
        • Blade tip to blade tip distance
        • Blade twist
        • Blade type attached to shaft
        • Blade tip to datum distances
    • Calibration
      • Zero Offset
        • Zero Offset calibration
      • Scale Factor
        • Blades-on Scale Factor Calibration
        • Scale Factor calibration
    • Advanced
      • Adjust your clamp
      • Remove and attach your sleeve
  • Dragon Boat
    • Assemble, Charge and Configure
      • Assemble
      • Charge
      • Configure
      • Sleep
  • High-Kneel Canoe
    • Getting Started
      • How to assemble a high-kneel canoe power meter
  • Outrigger Canoe
    • Getting Started
      • How to assemble an outrigger canoe power meter
      • How to set the outrigger canoe power meter settings
        • Blade tip to handle distance
        • Blade tip to bottom hand distance
        • Blade kickback angle
  • SUP
    • Getting Started
      • How to assemble a SUP power meter
      • How to set the SUP power meter settings
        • Blade tip to handle distance
        • Blade kickback angle
  • General
    • Web Bluetooth App
      • How to place the power meter in deep sleep
    • Updating Firmware
      • How to update the power meter firmware using the Web Browser
      • How to update the power meter firmware using nRF Connect
    • Real-time Data
      • How to pair a Garmin Forerunner 910XT with a power meter
      • How to pair a Garmin Edge 1030 with a power meter
    • High Speed Data
      • How to start/stop recording High Speed Data
      • How to download High Speed Data (ANT)
      • How to view High Speed Data
      • How to change the High Speed Data settings
    • Shaft Information
    • Model Descriptions
      • Power Meter
      • Power Meter w/ High Speed Data
    • Firmware Changelog
    • Manufacturer's Warranty
Powered by GitBook
On this page
  • Charging time
  • Charger placement
  • Right shaft
  • Left shaft
  1. Kayak
  2. Getting Started

Charge your kayak power meter

PreviousAssemble your kayak power meterNextConfigure your kayak power meter settings

Last updated 5 years ago

The left and right shafts of your kayak power meter will have been shipped to you in deep sleep mode. Before the power meter will operate you will need to attach the wireless charger to the left and the right shafts to force the shafts out of the deep sleep.

Charging time

Charging a battery from empty to full should take around 3.5 to 4 hours.

Charger placement

Right shaft

Left shaft