LogoLogo
Gen 3.0
Gen 3.0Gen 2.1Gen 3.1 & 3.2
Gen 3.0
Gen 3.0Gen 2.1Gen 3.1 & 3.2
  • Introduction
  • Kayak
    • Getting Started
      • Assemble your power meter
      • Charge your power meter
      • Configure your power meter settings
        • Blade tip to hand distances
        • Blade tip to blade tip distance
        • Blade twist
        • Blade type attached to shaft
        • Left blade tip to LED distance
    • Calibration
      • Zero Offset
        • Zero Offset calibration
      • Scale Factor
        • N channel Scale Factor calibration
        • O channel Scale Factor calibration
    • Advanced
      • Deep sleep
      • Adjust your clamp
      • Remove and attach your sleeve
  • Canoe/sup/dragon boat
    • Getting Started
      • Assemble
      • Charge
      • Configure
    • Calibration
      • Zero Offset
        • Perform a ZO calibration
      • Scale Factor
        • A channel Scale Factor calibration
    • Advanced
      • Deep sleep
      • Adjust your clamp
      • Remove and attach your sleeve
  • General
    • Web Bluetooth App
      • How to place the power meter in deep sleep
    • Updating Firmware
      • How to update the power meter firmware using the Web Browser
      • How to update the power meter firmware using nRF Connect
    • Real-time Data
      • How to pair a Garmin Forerunner 910XT with a power meter
      • How to pair a Garmin Edge 1030 with a power meter
    • High Speed Data
      • How to start/stop recording High Speed Data
      • How to download High Speed Data (ANT)
      • How to download High Speed Data (Automatic Script)
      • How to view High Speed Data
      • How to change the High Speed Data settings
    • Shaft Information
    • Model Descriptions
      • Power Meter
      • Power Meter w/ High Speed Data
    • Firmware Changelog
    • Manufacturer's Warranty
Powered by GitBook
On this page
  • Charging time
  • Charger placement
  1. Kayak
  2. Getting Started

Charge your power meter

PreviousAssemble your power meterNextConfigure your power meter settings

Last updated 3 years ago

Your kayak power meter will have been shipped to you in deep sleep mode. Before the power meter will operate you will need to attach the wireless charger to the left shaft to force it out of deep sleep.

Charging time

Charging a battery from empty to full should take around 3.5 to 4 hours.

Charger placement

locate the charger in line with the length scale and against the edge of the carbon shaft. A LED on the charger will blink green when you have it in the correct location.

If the LED on the charger will blink red if the charger position is off. Remove the power supply from the charger to reset.