LogoLogo
Gen 3.1 & 3.2
Gen 3.1 & 3.2
  • Introduction
  • Kayak
    • Assemble your power meter
    • Configure your power meter
      • Blade tip to hand distances
      • Blade tip to blade tip distance
      • Blade twist
      • Blade type attached to shaft
      • Left blade tip to LED distance
  • Canoe/Dragon Boat/SUP
    • Assemble your power meter (Gen 3.1)
    • Assemble your power meter (Gen 3.2)
    • Configure your power meter
      • Blade tip to hand distances
      • Blade type attached to shaft
      • Blade tip to LED distance
      • Shaft to handle offset distance
  • General
    • Battery Charging
    • Clamp Adjustment
    • Web Bluetooth App
    • Zero Offset Calibration
      • How to perform a Zero Offset calibration
    • Scale Factor Calibration
      • N channel Scale Factor calibration
      • O channel Scale Factor calibration
    • Updating Firmware
      • How to update the power meter firmware using the Web Browser
      • Latest firmware version
    • Real-time Data
      • How to pair with your device
    • High Speed Data
      • How to start/stop recording High Speed Data
      • How to download High Speed Data (ANT)
      • How to download High Speed Data (Automatic Script) - Experimental
      • How to view High Speed Data
    • Deep Sleep
    • GPS Sync Box
    • Metrics
      • Power
      • Force
    • Upgrade Description
    • Manufacturer's Warranty
    • Troubleshooting
      • High Speed Data Recording Fault
    • Shaft & Blade Sizing
    • Connections using hot melt glue
  • Training Guide
    • Functional Threshold Power
    • Power Zones
    • Fitness Tracking
    • Optimum Cadence
    • Technique Efficiency
    • Training to improve 30 second or 1 minute Power
    • Training to improve 4 minute Power
    • Training to improve Functional Threshold Power
    • Training to improve Endurance
Powered by GitBook
On this page
  • Step 1. Measure the distance from the left blade tip to the LED
  • Step 2. Enter the distances into the 'Left blade tip to LED distance' setting
  1. Kayak
  2. Configure your power meter

Left blade tip to LED distance

The distance from the left blade tip to the center of the LED

PreviousBlade type attached to shaftNextAssemble your power meter (Gen 3.1)

Last updated 8 months ago

Step 1. Measure the distance from the left blade tip to the LED

  • Attach the tape measure to the tip of the left blade (as shown below).

  • Measure the distance from the left blade tip to the center of the LED.

  • In the example image below the measurement is 1062 mm.

Step 2. Enter the distances into the 'Left blade tip to LED distance' setting

Ensure the distance is entered in millimeters and not centimeters