LogoLogo
Gen 3.1 & 3.2
Gen 3.1 & 3.2
  • Introduction
  • Kayak
    • Assemble your power meter
    • Configure your power meter
      • Blade tip to hand distances
      • Blade tip to blade tip distance
      • Blade twist
      • Blade type attached to shaft
      • Left blade tip to LED distance
  • Canoe/Dragon Boat/SUP
    • Assemble your power meter (Gen 3.1)
    • Assemble your power meter (Gen 3.2)
    • Configure your power meter
      • Blade tip to hand distances
      • Blade type attached to shaft
      • Blade tip to LED distance
      • Shaft to handle offset distance
  • General
    • Battery Charging
    • Clamp Adjustment
    • Web Bluetooth App
    • Zero Offset Calibration
      • How to perform a Zero Offset calibration
    • Scale Factor Calibration
      • N channel Scale Factor calibration
      • O channel Scale Factor calibration
    • Updating Firmware
      • How to update the power meter firmware using the Web Browser
      • Latest firmware version
    • Real-time Data
      • How to pair with your device
    • High Speed Data
      • How to start/stop recording High Speed Data
      • How to download High Speed Data (ANT)
      • How to download High Speed Data (Automatic Script) - Experimental
      • How to view High Speed Data
    • Deep Sleep
    • GPS Sync Box
    • Metrics
      • Power
      • Force
    • Upgrade Description
    • Manufacturer's Warranty
    • Troubleshooting
      • High Speed Data Recording Fault
    • Shaft & Blade Sizing
    • Connections using hot melt glue
  • Training Guide
    • Functional Threshold Power
    • Power Zones
    • Fitness Tracking
    • Optimum Cadence
    • Technique Efficiency
    • Training to improve 30 second or 1 minute Power
    • Training to improve 4 minute Power
    • Training to improve Functional Threshold Power
    • Training to improve Endurance
Powered by GitBook
On this page
  1. Canoe/Dragon Boat/SUP
  2. Configure your power meter

Shaft to handle offset distance

The distance that the handle is offset from the shaft axis

PreviousBlade tip to LED distanceNextBattery Charging

Last updated 8 months ago

If your handle sleeve has a bend, you will need to measure the distance that the handle is offset from the shaft axis (as shown by measurement in the image above).

Enter this distance (in mm) into the 'Shaft to handle offset distance' field on the .

Straight Shafts: Leave the shaft to handle offset distance set to 0 mm

One Giant Leap Bent Sleeves: Set the shaft to handle offset distance to 35 mm

Web Bluetooth App
Shaft to handle offset distance